Pitchlign Caged Roller Followers - With and Without Seals

IntroductionSelection GuideEngineering DataInterchangeCalculate Your SavingsReduce Your inventoryBrochure

Series SRF without seals



Part Number: SRF 40
Without Seals

D. Max: 2.000
Inside Diameter Nominal: 1
Corner Radius: 0.08
Approx Weight [lbs]: 0.590
Matching Inner Rings: IR 7194, IR 7194 C
Critical Angle [deg] 2: 41.8
Speed Limit [rpm] 3: 5400
Roller D Min: 1.999
Roller B Min +.000/-.005: 0.995
Inside Dia. Min: 1.0009
Inside Dia. Max: 1.0018
Bearing Dynamic Capacity C [lbf]: 6900
Bearing Static Capacity Co [lbf] 1: 11300
Track Capacity at 40 Rc [lbf]: 5200
Max: 1.0000
Min: 0.9995

All dimensions are in inches

Normal operating loads should not exceed the bearing dynamic capacity

Roller followers used without inner rings require a shaft with minimum hardness of Rc 58 and surface finish of 16 rms or better

Standard configuration of roller follower series SRF-- SS is with seal lips facing outward. To specify roller followers with seal lips facing inward, replace suffix -SS with suffix -RR. (example: SRF 30 RR)

  1. Bearing Static Capacity provided for comparison only
  2. For oscillatory application with angle of oscillation less than critical angle, consult RBC engineering department for revised fatigue calculation
  3. Speed limit of sealed roller followers is determined by maximum seal surface speed.
    For roller followers without seals, speed limit may be increased by 30% with oil lubrication.